10 Industrial Electrical Training Video Course Library -

Calculate expected full-load current given HP, voltage, and efficiency. Course 4: Motor Starters & Contactors Focus: Manual and magnetic starters, contactor operation, overload relays.

Using a schematic, find why a pump will not start – all indicators are off. Course 9: Electric Motor Maintenance & Failure Analysis Focus: Megger testing, bearing replacement, alignment, and winding evaluation. 10 Industrial Electrical Training Video Course Library

| Segment | Topic | Key Demo | |---------|-------|-----------| | 1 | NFPA 79 (Industrial Machinery) – key requirements | Panel labeling, wire colors | | 2 | Panel layout – component spacing, heat dissipation, wireways | Redesign a crowded panel | | 3 | Grounding & bonding – ground bar, shielded cable termination | PE terminal to backplane connection | | 4 | Wire types (MTW, THHN, TFFN) & ampacity tables | Select wire for a 30A circuit | | 5 | Short-circuit current rating (SCCR) of an assembled panel | Nameplate calculation example | Calculate expected full-load current given HP, voltage, and

| Segment | Topic | Key Demo | |---------|-------|-----------| | 1 | Megger test procedure – phase-to-phase & phase-to-ground | Acceptable values for 480V motor | | 2 | Surge comparison test for turn-to-turn shorts | Compare good vs. bad waveform | | 3 | Motor bearing types & replacement (grease vs. oil) | Pull a bearing with a puller | | 4 | Shaft alignment – dial indicator vs. laser alignment | Demonstrate soft foot | | 5 | Analyzing failed windings – overload, single-phasing, contamination | Show 5 failed stator photos | Course 9: Electric Motor Maintenance & Failure Analysis

Identify correct PPE for a Category 2 arc flash hazard. Course 2: Multimeter & Electrical Test Equipment Focus: Proper use of DMMs, clamp meters, insulation testers, and voltage testers.